Gigabit & 10 Giga Ethernet Switch VPX 6U - L3+ IP Router
The ComEth4340a is built on the latest generation of Gigabit switch engine and PHY transceiver. Its highly integrated chip combines in a single equipment a full layer 3 router with an optimized power consumption.
The ComEth4340a supports full-wire speed L2 bridging and L3 IPV4/V6 Unicast and Multicast routing with L2-L4 advanced traffic classification, filtering and prioritization. For instance, it can provide strict priority traffic and filtering needed for delay-sensitive or critical applications.
The ComEth4340a offers :
Thanks to software configuration, up to 16 * 1000KX ports can be used in 1000BT mode and routed on P5 & P6 connectors.
ComEth4340a models are also available with 4 * 1Gbe on the front panel (4 * 1000SX/ LX fiber channels or 4 * 1000BT copper ports). In these configurations, 20 * 1000KX ports remain available on the backplane (12 of them configurable as 1000BT).
24 x 1GbE & up to 4 x 10GbE ports with a full-wire speed switching capacity of 125 Mpps.
Layer2 Switching capabilities:
16K entries forwarding database
Automatic or controlled learning and aging routing table
Port and MAC access control
Flow control and backpressure
10 KB Jumbo Frame
IGMPv3 & MLDv2 snooping
Rapid Reconfiguration 802.1w
Link aggregation static or LACP
Unicast & Multicast rate limiting
Egress rate shaping with rate ranging port from 64K to 1Gbs
Minimal bandwidth guarantee per traffic Class
4K actives VLANs
4K Bridge mulcticast groups
Flexible VLAN assignment 802.1Q port -based, protocol based 802.1v, service Vlans 802.1ad, Policy-based Vlans
Quality of Service engine:
8 priority queues per port
Flexible bandwidth management with hierarchical shaping
Unicast and Multicast routing engine
RIPV2, OSPF V2 Routing proxy-ARP, DHCP relay
802.1X Port authentication
Virtual cable tester On-Line
Flexible management tools:
Web or CLI management
SNMP (Standard & private MIBs)
Enhanced Port mirroring
Easy software updating
24 1000KX ports (rear, P2/P3)
(16 of these 24 ports available on P5/P6 in 1000BT mode)
Two front XAUI/10Gig-CX4 ports
Two rear XAUI ports (P1)
(Alternate : 4 fronts ports : Fiber or Copper).
Auto-Negotiation with Downshift
Automatic MDI/MDIX crossover for all 3 speeds of operation.
Automatic polarity correction.
Online virtual cable tester.
Optional fast Ethernet out of band management port
Layer 2 switching
802.1D/Q Compliant with a full-line rate Ethernet switching engine
16000 MAC address database
automatic or controlled aging and learning mechanism,
Tag extraction and insertion
(802.1p), Jumbo frames up to 10KBytes.
Back pressure for half-duplex, IEEE802.3x for full-duplex.
Discard broadcasts above critical threshold.
Link aggregation with static or dynamic LACP (7 trunks of 8 channels)
Enhanced port mirroring.
IGMP v2,v3 & MLD v2 snooping.
802.1Q compliant : supports Layer 2 domain partitioning of up to 4000 ac-
VLAN is flexibly programmed to any value from 1 to 4094 Protocol-based
VLAN (802.1v) or Port-based VLAN (802.1v).
Port and MAC access control compliant with 802.1X authentication.
Eight queues per port.
Minimal and maximal bandwidth affectation per traffic class using weighted
round robin and strict priority scheduling.
128 quality of services profiles for traffic class drop precedence
L3 Hardware Engine for Unicast and Multicast routing
IGMP V2, V3
RIP V2, OSPF V2
UDP relay & DHCP proxy
STP/RSTP provides redundant link support.
L2 to L7 advanced traffic classification
Onboard firmware is implemented with comprehensive Built-In Test (loop back mode used during the diagnostic), maintenance functions and network
(BootP) updating functions.
Management software provides a wide range of configuration L2/3 functions on any port : transmission speed/mode, VLAN, STP parameters, mirroring, QoS, etc.
Supervision get lots of information in real time on the switch.MIB, RMON counters and private informations are reachable from SNMP agent, web-browser and CLI for L3 functions.
This Open Application, named SWITCHWARE, is carried out by a PowerPC processor.
Front panel LEDs
Power supply and Switch status
Switched ports : activity & link
Estimated Pmax = 30W (for 24 1000KX and 4 XAUI) TBC
5 VDC only
3.3 VDC Aux for optionnal management controller.
|Criterion||Standard||Extended||Rugged||Conduction-cooled 71°C||Conduction-cooled 85°C|
|Operat. Temp.||0 to 55°C||-20 to 65°C||-40°C to 71°C or 85°C (*)||-40°C to 71°C
at the thermal interface (*)
|-40°C to 85°C
at the thermal interface (*)
|Rec. airflow||1 .. 2 m/s||2 .. 3 m/s||2 .. 5 m/s||-||-|
|Oper. HR% no cond.||5 to 90%||5 to 95%||5 to 95%||5 to 95%||5 to 95%|
|Storage Temp.||-45°C to 85°C||-45°C to 85°C||-45°C to 100°C||-45°C to 100°C||-45°C to 100°C|
|Sinusoidal Vibr||2G [20..2000]Hz||2G [20..2000]Hz||5G [20..2000]Hz||5G [20..2000]Hz||5G [20..2000]Hz|
|Random Vibr||0.002g2 /Hz
|Shock 1/2 Sin. 11ms||20G||20G||40G||40G||40G|
Single Board Computers